![]() ![]() If ga!=60 then exit rules, skip outgoing actionīy doing this, at the cost of one global variable you could change the incoming channel for all shortcuts by changing only one translator. Translator: Shortcut Displatch (Session Record) If ga!=62 then exit rules, skip outgoing action Outgoing : One Shot Timer “ShortCut Dispatch” determine note and put into a global variable If oo!=14 then exit rules, skip outgoing action Incoming : Note-On any channel set to oo any note set to pp any value The way I would do it to allow me to change the incoming channel only once is: You would need to go through several translators and change them one by one. Say after you do this, you want to change the MIDI CH for all of your keyboard shortcuts from 15 to 14. I might have done it a little differently for future expansion however. The way you are doing it looks reasonable. Thanks for your time, very much appreciate it. I’m very happy with this, I just want to make sure I’m doing it properly before I assign the rest of the 64 pads I can now play with! Outgoing: Start/show: EXPLORER.EXE /n, /e, “E:\Sample I done this the correct way? It’s working but I’m wonder if there’s a best practice way to do this? Project MIDI OUT ports: Bome MIDI Translator 1 Virtual Out Project MIDI IN ports: MIDIIN2 (LPMiniMK3 MIDI) Project: LaunchPad Mini Mk3 Ableton Live Controller Without the routing, it simply only sends the keyboard shortcuts and nothing else gets though. I then switched the ports in Live, so now it gets the BMT-1 one instead of the usual LPM Mk3 etc.Īnd it’s working perfectly!!! It was the through routing that made the difference and also switching Live from the usual input port to the virtual BMT-1 one. It then dawned on me to use a MIDI through, so I used the routing option to route the usual port to my virtual one. the other midi channels) was getting to Live. At this point the translators worked fine, but nothing else (i.e. ![]() This worked fine, and everything triggered correctly.īut then I got slightly stuck when I wanted everything on other MIDI channels other than 15 to still get through to Live. The outputs work fine, some are keyboard shortcuts and one to open Explorer. I’ve created the translators for each action, assigned them to the input MIDI and they’re set to ch15. I want to use MIDI channel 15 as my “keyboard shorts channel” and assign individual MIDI notes on channel 15 to trigger keyboard shortcuts but also have those same MIDI notes being blocked from getting to Live as MIDI notes. I’ve got it working perfectly, but I’d just like to check I’ve done it correctly and I’ve not over complicated anything! I’m setting up my LaunchPad Mink Mk3, so that the “User” set of pads trigger keyboard shortcuts in Ableton Live, so I can have a pad to open Live’s browser, or toggle the metronome etc. Hi All, I’m just starting with the trial version of BMT Pro and love it so far, most likely I’ll be purchasing it in the next day or so! ![]()
0 Comments
Leave a Reply. |